Featured Suppliers:

A set of 270 pairs of gas valves, supplied fully machined, assembled and pressure tested with full traceability for both body and spool back to a certficated melt number.

http://www.durhamfoundry.com/casestudy_bridge.htm

An innovative hybrid insulation system, consisting of three CertainTeed Insulation products, has contributed toward the LEED® Platinum certification of a home featured in the 2008 ENERGY STAR® Summit.

http://www.certainteed.net/idea-center/case-studies/insulation/?csid=70

Case Study Window Frames for Dock Development in London - Cast Iron

A range of cast iron window frames which were produced to meet the requirements of English Heritage and also meet current building regulations. This entailed redesigning them to accept individual double glazed panels and a secure and water proof opening.

http://www.durhamfoundry.com/casestudy_frames.htm

Case Study Solid Top Cooker - Cast Iron

Step 1 The set of patterns ready for moulding. Each set consists of two rectangular end sections, a large round middle section and a small round centre section.

http://www.durhamfoundry.com/casestudy_cooker.htm

Case Study Gas Reversing Valves - Cast Iron

Please browse our website for more information about Durham Foundry and our ability to manufacture Cast Iron and then contact us on 0114 249 4977 or e-mail us on castings@durhamfoundry.com

http://www.durhamfoundry.com/casestudy_floorgates.htm

Case Study Refurbishment of a Victorian Fountain in Hull - Cast Iron

Step 5 The fountain reassembled and erected on site. It is hoped to produce a further two complete fountains to replace ones which were removed during the fourties.

http://www.durhamfoundry.com/casestudy_fountain.htm

Case Study Floor Grates for Victorian Glass House - Cast Iron

Step 2 The material was a ductile iron to BS EN 1563 450/10. The specification controlled chemical analysis, mechanical test and hardness with each bearing being traceable to a certified melt number.

http://www.durhamfoundry.com/casestudy_bearings.htm

Case Study Casting for large Automotive Manufacturer - Cast Iron

Step 3 Fettling the casting. This operation removes the runner and riser system and cleans any flash from the joint line. The casting is then shotblast, sent for stress relieving and finally tested by Magnetic Particle Inspection to check for cracks. No cracks were found.

http://www.durhamfoundry.com/casestudy_moss.htm